Skip to content

Infinitybox Reference Documentation

Quick reference for Infinitybox NGX system configuration and wiring.

Support: 847-232-1991

Official Resources

Topic Link
Wiring Diagrams & Resources https://infinitybox.com/wiring-diagrams-resources/
Setting Address Jumpers https://infinitybox.com/wiring/setting-address-jumpers/
Automatic Headlights https://infinitybox.com/wiring/automatic-headlights/
POWERCELL Output https://infinitybox.com/wiring/powercell-output/
Cell Outline Drawings https://infinitybox.com/wiring/infinitybox-cell-outline-drawings/
CAD Models https://infinitybox.com/wiring/infinitybox-cad-models/
Updating with inCODE https://infinitybox.com/software/updating-with-incode/
Haltech ECU Wiring https://infinitybox.com/wiring/haltech-ecu-wiring-diagram/
VaporWorx Fuel Pump Controller https://infinitybox.com/wiring/wiring-vaporworx-fuel-pump-controller/
Parking Lights https://infinitybox.com/wiring/parking-lights/

POWERCELL / inMOTION Address Jumpers

Cells use BCD (Binary Coded Decimal) to set addresses via 4 jumper pins.

Jumper Values

Pin Position Value
1st (leftmost) 1
2nd 2
3rd 4
4th (rightmost) 8

Address = sum of pins WITHOUT jumpers

Standard Addresses (20-Circuit Kit)

Cell Address Jumper Configuration
Front POWERCELL 1 Remove jumper on pin 1, keep rest
Rear POWERCELL 2 Remove jumper on pin 2, keep rest
inMOTION 3 Remove jumpers on pins 1 & 2, keep rest
Additional POWERCELL 4 Remove jumper on pin 4, keep rest

Important Notes

  • Cells read address only at power-up
  • Disconnect power before changing jumpers
  • Verify address settings before final installation

Kit Contents (Standard 20-Circuit)

  • 1x MASTERCELL (input controller)
  • 2x POWERCELL (output modules, 10 outputs each)
  • Pre-built harnesses with pig-tail terminations
  • CAN bus cables

Additional Components (Trader-01 Order)

  • 4x inMOTION cells (door modules)
  • inVERT Mini (turn signal flasher)
  • Additional POWERCELL NGX (pending)
  • inCODE NGX Programmer (pending)
  • inLINK NGX Wireless Interface (pending)

CAN Network Architecture

MASTERCELL (Address: 0 / Master)
     │
     ├── CAN Bus ──┬── POWERCELL #1 (Front, Address: 1)
     │             │
     │             ├── POWERCELL #2 (Rear, Address: 2)
     │             │
     │             ├── inMOTION #1 (Address: 3)
     │             ├── inMOTION #2 (Address: 4)
     │             ├── inMOTION #3 (Address: 5)
     │             └── inMOTION #4 (Address: 6)
     │
     └── inLINK (Wireless Interface)

Wiring Tips from Jay @ Infinitybox

  1. Harness pig-tails: Cut to length and crimp your own terminals
  2. Existing lights: Use butt-splices or fast-on connectors
  3. Steering column: May need mating connector depending on column type
  4. Ground strategy: Star-point grounds to battery negative when possible
  5. Address jumpers: Set before mounting cells in final location